Instructions
Clover & Cove's Showerhead Installation Manual
What’s Included:
- 1 x Showerhead (with 1 built-in filter)
- 3 x Extra filters
- 1 Hose
- 1 Connector
Tools Required:
- Adjustable wrench (optional)
Installation Steps:
-
Turn Off Water Supply:
Ensure the water supply to your shower is completely turned off before starting the installation. -
Remove Old Showerhead:
Unscrew your existing showerhead by hand or with an adjustable wrench. Be cautious of any residual water that may drip. -
Clean the Shower Arm:
Clean the threaded end of the shower arm to remove any old plumber’s tape, debris, or residue for a proper seal. -
Apply Plumber’s Tape:
Wrap the threaded end of the shower arm with the plumber’s tape if necessary to ensure a tight, leak-free seal. -
Attach the Connector:
Screw the connector onto the threaded end of the shower arm. Hand-tighten until snug, but avoid over-tightening. -
Attach the Hose:
Connect one end of the hose to the installed connector, ensuring it’s securely tightened by hand. -
Attach the Showerhead:
Connect the other end of the hose to the showerhead. Hand-tighten it until secure. -
Turn On Water Supply:
Slowly turn the water supply back on and check for any leaks around the connections. If leaks are found, tighten all connections properly. -
Adjust Showerhead Position:
Adjust the showerhead to your preferred position, if applicable. -
Test the Showerhead:
Turn on the shower to ensure it operates correctly and check for leaks.
Troubleshooting:
-
Leaking at Connections:
Check all connections to ensure they are hand-tightened. If necessary, reapply plumber’s tape to create a tighter seal. -
Low Water Pressure:
Ensure the hose and showerhead are not obstructed and are properly connected.
Safety Tips:
- Avoid over-tightening connections as it may cause damage.
- Always ensure the water supply is completely turned off before starting the installation.
Contact Us